Level 1 Probe Training (September 2026)
Schedule
Tue Sep 01 2026 at 09:00 am to 04:00 pm
UTC-04:00Location
176 Kelsey St | Newington, CT
About this Event
Level 1 Probe Training Course
Learn the fundamentals of machine tool probing and enhance the efficiency of your machining centers and lathes. This class will be taught on an Okuma machine, but 90% of the course is control-agnostic.
This course will cover the following topics:
- What is a probe and how does it function?
- How to perform first-time setup on a probe or replace a damaged stylus
- How to pair and calibrate a probe
- Calibration types and best practices
- How and when to configure trigger logic
- Introduction to Set & Inspect, GoProbe, and Reporter softwares
Earn a Certificate of Completion from Renishaw at the end of the course.
PLEASE NOTE
There are 2 seperate sessions. Please register for the day you prefer as both sessions will cover the same material.
For more information, contact Ian Raupach.
Email: [email protected]
Phone: +1 (847) 703-0350
Where is it happening?
176 Kelsey St, 176 Kelsey Street, Newington, United StatesEvent Location & Nearby Stays:
USD 0.00
















