3D Printer : BUS (Basic Use and Safety)
About this Event
Ultimaker 3D Printer : BUS (Basic Use and Safety)
In this one time Basic Use and Safety workshop, students will learn how to safely set up and use our Ultimaker 3D printers.
Completion of this single 1 hour class certifies students to use the 3D printers independently as a Makerspace NYC member or a non-member on a day pass (at the instructor's discretion). Students will learn how to operate the Ultimaker 3D printer and use the requisite software for their designs.
Requirements
Open to all, ages 18+
Current sessions and pricing:
Sunday, July 12th- 1:30 - 2:30pm
Sunday, July 19th - 1:30 - 2:30pm
$110.00 non-members // $95.00 members
(membership will be verified upon purchase)
Refunds/Cancellations:
If we cancel, we will refund you and notify you. You may cancel and get a full refund up to three days before the class. After that, refunds are contingent on us being able to fill your seat. Under no circumstances do we offer refunds to individuals who cancel on the same day. This ruins the party for everyone. Please note that if you cancel, the Eventbrite fees are non-refundable.
Location:
Makerspace NYC
Brooklyn Army Terminal
140 58th St Building B, Unit 1C
Located on the first floor next to Pete's Restaurant
For detailed directions by car (free parking), subway or ferry go to:
https://www.bklynarmyterminal.com/location/directions/
Where is it happening?
Event Location & Nearby Stays:
USD 103.22 to USD 119.22
